Product Features：
● JAR Return Tank is a high -performance single -piston air pressure rotating cylinder product
● Provide a strong piston push/tension with a small amount of air leakage
● Designed for driving CNC small three -claws or tube clip head
● Drive the front chip with air pressure, there are two ways to work before pushing before.
● The cylinder body is not heated when the air pressure rotation cylinder works at high speed.
● Qi source interrupt workpiece will not fall off, set up self -locking function
● Adopting the principle of air floating, the long life of the bearing is not difficult to use

Product Application：
● The maximum pore pore diameter is ∮63 (reference to the main axis tail pipe selection configuration hole diameter)
● The installation method is the main axis tail pipe directly set
● Pickled driver configuration commonly used in small and medium -scale CNC lathes
● The driver of traditional machine tools is simpler and fast.
● The piston stroke design can be increased to 20mm
● The highest speed 4000rpm/min/min

Product Features：
● The JA series is a high -performance dual -performance dual -piston rotating cylinder product
● Provide a strong double piston push/tension with trace air leakage
● Designed for driving CNC three -claws or tube clip head
● The rotating cylinder drives the front chip by the air pressure.
● The cylinder body is not heated when the air pressure rotation cylinder works at high speed.
● Qi source interrupt workpiece will not fall off, set up self -locking function
● Model "D" is the post -pull "P" as the front push type

Product Application：
● The maximum pore pore diameter is ∮42
● Use rear flange connection installation
● Pickled driver configuration commonly used in small and medium -scale CNC lathes
● The driver of traditional machine tools is simpler and fast.
● Piston Stroke design can increase to 25mm

Product Features
● Rotating cylinder ontology Rotate accuracy ≤0.01mm.
● The structure of the heating treatment of steel integrated, the bearings have no overload, high steel and stability, long life, temperature rise and low
● The front end can be equipped with an inner -supported passive chip and the outer clip.
● Direct flanges are connected to the main axis, convenient and fast installation, and controlled the machine tool system through the solenoid valve
● Quickly replace the lever to facilitate product replacement, and you can control the length of the work holding normally.
● The oil pressure clamping force is large, and the relative speed is low

Product Suitability
● Heavy cutting, suitable for shaft type gear rubbing machine